Shopping Cart 0 items
log in register
Today's Deals Forum Desktop Site
All Categories
Featured
Brands
Development
Sensors
Tools
Miscellaneous
Components
E-Textiles
Robotics
Wireless & IoT
Audio

Creative Commons images are CC BY 2.0

Favorited Favorite 29
Wish List

Slide Pot - Small (10k Linear Taper)

A simple slide potentiometer can go a long way. Rated at 10KOhm and 0.1W. Comes with solder tab connections. The pot has an overall travel of 20mm and has two mounting holes on top.

  • 9.5mm x 35mm

Tags

Slide Pot - Small (10k Linear Taper) Product Help and Resources

Core Skill: Soldering

This skill defines how difficult the soldering is on a particular product. It might be a couple simple solder joints, or require special reflow tools.

1 Soldering

Skill Level: Noob - Some basic soldering is required, but it is limited to a just a few pins, basic through-hole soldering, and couple (if any) polarized components. A basic soldering iron is all you should need.
See all skill levels

Comments

Looking for answers to technical questions?

We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.

  • 9020 / about 6 years ago * / 1

    cad file anyone?

  • 9020 / about 6 years ago * / 1

    "two mounting holes on top" ... to mount with what? m3 screw doesnt fit; is it m1, m2 or m2.5?

  • 9020 / about 6 years ago * / 1

    The travel area is more than 20 mm.

  • Member #142965 / about 7 years ago / 1

    The photo shows 3 terminals and different mounting tabs than are shown in the PDF spec sheet, which shows 6 terminals (2 duplicates for each terminal) - can you confirm which of the two is actually correct?

  • Taqyon / about 8 years ago / 1

    Are there any knobs available for the slider?

  • Member #900758 / about 8 years ago / 1

    The pinout for this is as follows: Pins 1 & 3 are positive/ground, and pin 2 is the analog wiper. This component doesn't care which end is positive and which is ground, but reversing these will also reverse the direction/value of the wiper.

  • Member #467108 / about 9 years ago / 1

    I'm guessing that I could use this as a replacement slide pot on the SF Digital Sandbox, correct? I see it has the same dimensions.

  • sparkfunkov / about 9 years ago / 2

    How are these wired please?

  • Member #117056 / about 10 years ago / 1

    Could this be used as a crossfader? I see there are pins on either end of the slider -- if I hooked up two audio channels, would it apply, e.g. 0K resistance to one and 20K to the other?

Customer Reviews

No reviews yet.