This is the new, weather resistant, field-hardened WR from Maxbotix. The XL series of this sensor features higher resolution, longer range, higher power output and better calibration.

The WR uses a robust PVC housing, is designed to meet IP67 water intrusion, and matches standard electrical 3/4" PVC pipe fittings. The sensor provides very accurate readings from 0 to 765cm (0 to 25.1ft) with 1cm resolution. This sensor can be powered with anywhere between 3.3 and 5VDC.

Range information can be gathered through one of three methods - analog, serial, or PWM - all of which are active at the same time. The analog output will produce a voltage proportional to the measured distance, with a sensitivity of (Vcc/1024)V/cm. The serial interface is simple and formatted to RS-232, with voltages ranging from 0 to Vcc and terminal settings of 9600-8-N-1. Finally, the PWM pin outputs a pulse-width representation of the range with a scale factor of 58us/cm.

• 3.3V to 5V supply with very low average current draw
• All interfaces are active simultaneously
  • Serial, 0 to Vcc
  • 9600 baud, 8-N-1
  • Analog, (Vcc/1024) / cm resolution
  • Pulse Width
• High acoustic power output
• Real-time auto calibration and noise rejection for every ranging cycle
• Precise narrow beam
• Continuously variable gain
• Object detection includes zero range objects
• Readings can occur up to every 100mS, (10-Hz rate)
• Free run operation can continually measure and output range information
• Triggered operation provides the range reading as desired
• Sensor operates at 42KHz

• Datasheet (MB7060)
• Sensor Selection Guide
• Beam Width Explanation