USB Female Type B Vertical Connector

USB female 'Type B' connector in a vertical mounting configuration. The 4 connection pins have 0.1" spacing allowing it to be inserted into development boards and perf boards with mild modification. You can either drill two 80mil holes for the support posts, or cut them off completely.

USB Female Type B Vertical Connector Product Help and Resources

Core Skill: Soldering

This skill defines how difficult the soldering is on a particular product. It might be a couple simple solder joints, or require special reflow tools.

1 Soldering

Skill Level: Noob - Some basic soldering is required, but it is limited to a just a few pins, basic through-hole soldering, and couple (if any) polarized components. A basic soldering iron is all you should need.
See all skill levels


Comments

Looking for answers to technical questions?

We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.

  • PointyOintment / about 10 years ago / 1

    Datasheet doesn't seem to mention this connector.

  • Member #449160 / about 11 years ago / 1

    Since this will fit into a breadboard, how sturdy are the support posts for being bent/rebent, like if I bent them completely to the sides for the breadboard, would I be able to bend them back into place for the final piece or would they be too fragile for that?

    • You'd probably end up breaking them off bending and rebending them. I'd recommend either just cutting them off, or using the breakout board (listed below in the related products), which allows you to add this into a breadboard and have 4 mounting holes available for securing the port.

  • kewakl / about 12 years ago / 1

    wonderfully washed-out picures

  • Doctor Who / about 14 years ago / 1

    And of course this thing is just dandy.

Customer Reviews

No reviews yet.