- Home
- Product Categories
- Wire
- Molex Jumper 3 Wire Assembly
Molex Jumper 3 Wire Assembly
This is a simple three wire cable. Great for jumping from board to board or just about anything else. There is a 3-pin Molex connector with 0.1" spacing on one end, bare cable on the opposite end. It also comes with the mating connector for the Molex.
- 6" length
Molex Jumper 3 Wire Assembly Product Help and Resources
Core Skill: Soldering
This skill defines how difficult the soldering is on a particular product. It might be a couple simple solder joints, or require special reflow tools.
Skill Level: Noob - Some basic soldering is required, but it is limited to a just a few pins, basic through-hole soldering, and couple (if any) polarized components. A basic soldering iron is all you should need.
See all skill levels
Comments
Looking for answers to technical questions?
We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.
Customer Reviews
No reviews yet.
As it happens, this is the same type of connector found in PC fans
Now that this item has been retired, will there be something nearly identical to take its place?
The datasheet doesnt show any dimensional information.
What is the width of the square leads on the connector end?
Hi, what is the part number for the male and female Molex connectors used in this cable assembly?
in the photo with the black background, what is the item with the three prongs called? is that the mating connector that comes with it?
Wow, I wish I'd seen these before buying the jst jumper assemblies. Easier mechanical operation and 0.1" spacing!