Prototyper
Member Since: September 22, 2014
Country: Switzerland
-
Hello everybody,
I'm new here and have some questions. I just wants to start with my new quadstepper. It is for a special 3D-Printer. As controller I have the RUMBA-board. Istead to use one DRV8825 I will take the quadstepper for the Z-axis. My objective is to control 4 motors with 6 pins.
Am I right to enable the 4 bridges for "ebable" and 4 "direction? The 5V bridge has also to be enabled? What else I have to do?
Thanks a lot for your comments and greetings from Switzerland Otto
No public wish lists :(