Knobs are a great way to finish off your project and make it easier to adjust the level of your death ray. This knob mates to a 6mm (+/- 0.3mm) shaft. The knob slides onto the potentiometer and holds tightly with a strong friction fit.
The main body of these knobs is metal with a plastic insert. The outside is knurled for precise adjustment.
We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.
Based on 1 ratings:
2 of 2 found this helpful:
These knobs look fantastic and should fit any pot with a 1/4-inch shaft. The metal body is sturdy and feels great to operate. Very retro look and feel. The only downside is that the plastic insert can deform if you remove and replace the knob a lot. So put them on your pots when your project is done and leave them there.
Its nice, but its cheaper on other sites.
Is it possible to source this without the indicator for use with the rotary encoders?
This knob fits great on the 10k Ohm Potentiometer
Is this compatible with COM-09288?
Doesn't look like it is, the underside of it has little bumps that look like they fit on COM 09939 and others.