Mega Pro Mini Cable - 8" (8-wire)

This is a wire assembly terminated with the same 8-pin JST-SH connector which is on the Mega Pro Mini. Pick up a few of these to break out all of those pesky pins. Integrating these connectors into your projects makes it possible to quickly swap out a Mega Pro Mini between two or more different enclosures. One end is terminated with a JST-SH connector and the other end is tinned bare wire leads.

Note: It takes 10 of these cables to break out every pin on the Mega Pro Mini, so make sure that you order enough for your application.

Note: The color of these wires may change from batch to batch so be sure to check your pinouts!

  • 8" length

Comments

Looking for answers to technical questions?

We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.

  • Member #136467 / about 11 years ago / 5

    Why, for the love of God, do you not carry the socket that goes to this cable?!!!!!!!!!! SOOOOOoooooooo many other things to use it for than just the Mega Pro mini, and I'm sure you'd sell more.

  • Member #292280 / about 13 years ago / 2

    Just as an FYI: This cable fits the 32 Channel San Jose Navigation GPS Module

    Sparkfun, can we get this listed on the GPS section and/or as a related product on the product page?

  • DigitalWorld / about 13 years ago / 1

    I think breadboard-friendly male termination (like the breadboard wires sold here) would be nice in this application.

    • Member #228962 / about 13 years ago / 1

      +1 agree. Tinned bare wires are better than non-tinned bare wires, but I'd prefer either male or female jumper cables on the other end.

Customer Reviews

No reviews yet.