- Home
- Product Categories
- Robotics
- Mini Metal Gearmotor 26:1 (438 RPM)
Mini Metal Gearmotor 26:1 (438 RPM)
This motor has a 3mm D-shaped metal output shaft that matches the Pololu wheel 42x19mm and 32x7mm. The face plate has two mounting holes threaded for M2 screws.
These motors are intended for use at 6V. In general, these kinds of motors can run at voltages above and below this nominal voltage, so they should comfortably operate in the 3 – 9 V range. Lower voltages might not be practical, and higher voltages could start negatively affecting the life of the motor.
Replaces:ROB-8913
- 25:1 gear ratio
- 438rpm @ 6V
- 44mA @ 6V
- 6 oz inches torque @ 6V
Mini Metal Gearmotor 26:1 (438 RPM) Product Help and Resources
Core Skill: Robotics
This skill concerns mechanical and robotics knowledge. You may need to know how mechanical parts interact, how motors work, or how to use motor drivers and controllers.
Skill Level: Rookie - You will be required to know some basics about motors, basic motor drivers and how simple robotic motion can be accomplished.
See all skill levels
Core Skill: Electrical Prototyping
If it requires power, you need to know how much, what all the pins do, and how to hook it up. You may need to reference datasheets, schematics, and know the ins and outs of electronics.
Skill Level: Rookie - You may be required to know a bit more about the component, such as orientation, or how to hook it up, in addition to power requirements. You will need to understand polarized components.
See all skill levels
Comments
Looking for answers to technical questions?
We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.
Customer Reviews
No reviews yet.
Will this motor interfere with this? https://www.sparkfun.com/products/10530
from my experience, these are EMI bombs. Make sure you don't have any non-differential encoders or other sensitive parts in the system.
like this maybe? https://www.sparkfun.com/products/10530
Have you tried placing a small ceramic capacitor across the motor terminals?
In description you say it has a 7mm D-shaped shaft, but it is 3mm. And wich reduction ratio is correct 26:1 (title) or 25:1 (features)?
I think the 7mm is not diameter, but length.
Will sparkfun carry motors that are good for DIY multi-copters?
Indeed: A few nice brushless motors would be awesome.