Member Since: August 7, 2019
Country: United States
Tutorial - OBD II UART Hookup Guide about 5 years ago
Problems Using OBDII UART with minicom
DESC: Upon attempting to connect minicom to /dev/ttyUSB0 as specied in "First Communication", I ran into an issue where I would get no responses when I sent commands. However, I knew the board was working, because when I unplugged and replugged the DB9 connector, I recieved the startup message over the terminal.
SOLN: After some short perusal of StackOverflow, I found this link. The gist of the problem was that my "Hardware Flow Control" setting was set to "Yes" instead of "No". Upon changing this setting to "No", commands worked as normal.
No public wish lists :(