Member Since: April 7, 2008
Country: United States
Looks and fits beautifully! However it was designed with the revision 1 RPi. It has the same misprint on it that the Rev1 RPi has. It says "10M" on it but it should say "100M". Also there is no opening for P6 which is the reset button header..
Crappy video:
http://www.vimeo.com/3293393
Oh man you gotta be kidding me....
I had somehow mixed up and swapped by base and remote xbee !!
Now everything works as it should!
Please erase all these embarrassing posts!!
When you mention this "Screamer should reset the remote unit setting off the bootloader and the unit should start downloading blink-v10.hex. "
Its not doing that for me. I get the message "Waiting for target IC to boot broadcast"
So when I reach over and reset the target manually it then uploads.
So why isn't it sending a reset?
Sorry...it works only if i manually reach over and hit the reset button
Yeah I can't run it twice in a row without the status saying "Waiting for target IC to boot broadcast' What am I missing here?
Why aren't we doing RTS on close anyway?
http://www.engadget.com/2006/03/07/how-to-make-a-surface-mount-soldering-iron/
http://www.instructables.com/id/E28EU7361LEV2ZAACQ/
http://www.gideontech.com/content/articles/297/1
http://www.usbmicro.com/odn/documents/ACC430664DD26DDE5986574AAA62775FDFF29EA1.html
So I went to try doing this a second time and it didn't work. I am thinking that it is because I didn't set the lock bits properly to protect the bootloader from being overwritten. I'll let everyone know when I get a chance in the next day or two to look at this closer.
I can be dense at times, but after reading the datasheet I'm still scratching my head....Is there any tutorial on how to actually wire this up to your MCU? (preferably a mega8/168/328)
I'm here to report that this worked uploading my full robot hex of 32KB with absolutely no problems!!!
No public wish lists :(