t-storm
Member Since: January 21, 2009
Country: United States
-
Hello, I have a spindle motor for a DIY engraver that is 100V and 500W so 5 Amps? Would this board be able to handle the 100VDC? I'd really like to measure the current since one of our motors likes to stall out, I plan on killing the power to the motor if the current rises to high. Thanks
-
Thank you for the reply, sorry it has been so long. Is there a fully dimensioned file for the entire part? Or even a .step file available?
-
Is there a panel file that gives dimensions?
-
Reshoring!
-
A cancer you can cure with a fudged birth certificate!
-
I'm upset you let someone with a June birthday post.
-
I just ordered a DCP-USBCB-SC (micro USB to solder holes) and a cap 6295 (Both are Switchcraft products). The hole is .69 dia. flattened to .582 on one side. I was wondering if Sparkfun could offer a more custom weather proof enclosure. Like have some standard options for feed throughs and where they are located. I'm just thinking SF might have the knockout punches available for different connectors that a hobbyist wouldn't have on hand.
-
Maybe a Pi-Ion battery?
-
I recently purchased a water flow sensor that had this same connector and nobody could tell me what it was. I eventually found it and this was the Amazon description:
Hilitchi 520Pcs 2.5mm Pitch 2 3 4 5 Pin JST SM Male & Female Plug Housing and Male/female Pin Header Crimp Terminals Connector Kit
You will also need something similar to the following Sparkfun product:
Crimping Pliers - 28-20 AWG, TOL-13193
And some stranded wire.
I'm sorry if this was talking out of turn but I've found those connector kits to be very handy.
-
Hello, I'd like to use 2 of these with one Photon, I was looking in the build library and I can't quite see how to address them. Is this possible? Thank you.
