Member Since: February 19, 2009
Country: United States
Product SEN-09673 about 10 years ago
after playing with 2 of these, the silver ink cracked near the crimped on connector. after the 1st one cracked i was very careful with the 2nd one and tried to not bend it much and taped it to a rigid backing, but after a while the ink again cracked and the sensor was useless. anyone have any ideas for a solution?
Product SEN-09376 about 10 years ago
i too saw the ink crack with very little bending, anyone have any input on a solution?
Product COM-11192 about 13 years ago
what is the contact rating of the switch??
News - New Product Friday: Look … about 13 years ago
what is the "local robot convention" you are attending?
Tutorial - Nest Teardown about 13 years ago
I expect that the temperature sensor is the little board next to the PIR. Room air would convect up through the notch in the case.
News - Check out the GardenBot about 14 years ago
Be careful with the light sensor, CDS cells do not stand up to moisture well. freeze/thaw = tiny crack = tiny bit of water inside = bad cell very quickly.
No public wish lists :(